Brains trust, I need help.
I've had my Photon-S for a few months. All my prints have been going really well up until today. I havent used it in a week and last week I did a bunch of printable and one 1 out of the 6 I did had to be redone due to failure to adhere.
My settings are as follows:
.025 layer height
8 bottom layers
120s bottom layer exposure time
12.5s layer exposure time
1.5s light off
I have had 9 failures today alone.
I have tried using different files, I've tried using different settings by playing with shorter or longer exposure times, different layer counts, I replaced the FEP film after my 3rd failure, I've re-leveled and re Z=0 the plate with each failure, I've heated the resin and plate up with a hair dryer to make sure they are correct temp, I was previously using Monocure Rapid Clear and had excellent results with it, so I switched back and used my original settings, but it's now still sticking to the FEP film 100% of the time.
I went on the github page for the photon and went through every item on the "print sticking to FEP film" checklist and it should all be fine in theory.
I've added a video showing the movement of the printer, when it rises it looks like the print is stuck to the FEP film before its pulled off (you can hear it with sound on).
I'm at a loss as to what is causing it.
翻譯年糕
Bud Geldmacher
2019-06-29 21:46:33
Sam Ellis
2019-06-29 22:00:29
Ionut Filea
2019-06-29 23:02:33
Stefan Lukus
2019-06-30 00:06:31
Mothy Reynolds
2019-06-30 01:22:50
Richard Webb
2019-06-30 02:44:49
Sam Ellis
2019-06-30 06:52:59
Sam Ellis
2019-06-30 06:55:33
Will Koehler
2019-06-30 07:08:25
Alex Munro
2019-06-30 07:08:32
Pierre Lasnier
2019-06-30 17:46:12
Robert Cvengros
2019-06-30 20:01:22
TimSultan Sultan
2019-07-01 05:21:19
Richard Webb
2019-07-01 05:23:24
Sam Ellis
2019-07-02 08:07:20
Marvel Mendoza
2019-07-04 14:21:45
Sam Ellis
2019-07-04 15:01:40
