So after my first print which came out great, I had a series of failed prints, where the print was just stuck to the FEP sheet. I figured it might be a poor leveling job because I was pretty excited to get started and may not have done it as appropriately as possible. I followed the flint read method and attempted another print, and printed this really tiny dragon, but then, once again after this print, all the rest are falling off the plate and sticking to that vat. I paused one at around 10% just to check and it was on the plate, but by 25% it had adhered to the FEP sheet. I've tried increase the exposure time to well above the recommended settings for the Anycubic Clear Green and I set the bottom layer exposure to 140 just as a safety precaution but they continue to fail. Any ideas?
翻譯年糕
Alex Munro
2019-07-14 08:01:11
Susan Sioux Mercer
2019-07-14 08:04:06
Andrew Mills
2019-07-14 08:07:59
Susan Sioux Mercer
2019-07-14 08:09:22
Mark Wardle
2019-07-14 08:11:16
Andrew Mills
2019-07-14 08:13:39
Mark Wardle
2019-07-14 08:20:59
Stefan Giudici
2019-07-14 08:58:00
Andrew Mills
2019-07-14 08:58:51
Andrew Mills
2019-07-14 09:01:24
Mike Fatchett
2019-07-14 09:36:44
Chasen Harris
2019-07-14 10:03:20
Stefan Giudici
2019-07-14 11:43:43
