Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Chris Edrington
2019-10-30 21:25:57

By far the largest project I’ve done with my Photon (base printed with my Prusa).

Still some finishing work to do on it, but very happy with the results so far.

Everything printed at 40% scale.

Be sure to turn your sound on as well ?

翻譯年糕

Darren Ng
2019-10-31 11:03:26

Chris Edrington
2019-10-31 21:28:42

原文網址 Chris Edrington
2019-07-19 04:35:28

Is there somewhere (in the States) to buy empty resin bottles for storing pre-mixed resin combos?

I have yet to empty a full bottle so looking for an alternative

翻譯年糕

Dave Smith
2019-07-19 04:37:21

Richard Shapiro
2019-07-19 04:37:27

Sean Croteau
2019-07-19 04:38:33

James Wei
2019-07-19 04:40:53

Stefan Giudici
2019-07-19 04:46:32

Tori Beckett
2019-07-19 05:10:52

Chris Edrington
2019-07-19 08:05:25

原文網址 Chris Edrington
2019-07-15 19:54:17

UPDATE: Third USB drive resulted in a successful print, thanks for the replies/guidance in troubleshooting this issue

Need some help please.

New Photon, I leveled the bed and tried to print and failed. Realized the bed wasn’t as level as it needed so I releveled it and looked to have a successful print going on. When I checked on it hours later, it appeared to be stuck/paused and would not finish the print.

I tried again and it looks to have failed at the same spot, only this time it completed the print (the remainder of the model is stuck on the FEP)

This is the starter print from Anycubic. Using the supplied green resin.

The supplied USB drive was corrupted out of the box so I used my own and downloaded the .photon file. After the first failure I thought maybe my USB drive was bad, so I used a different one for the second print.

Any ideas?

翻譯年糕