Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Jön Paulson
2019-08-15 04:35:41

I returned my Photon since it was a piece of garbage. Unfortunately I have a bunch of extra stuff that's now useless to me, is anyone interested in a set of FEP sheets and 1L of grey resin?

The resin was opened and poured enough to do one print of the test cube, it was strained and added back to the bottle. So it's about 95-97% of the bottle.

The FEP sheets are a 4 pack that I got on Amazon from 3D print club, 100micron .1mm thick. Still in the package.

翻譯年糕

Darrell Schwark
2019-08-15 04:38:04

Paul Youdelis
2019-08-15 04:38:09

Paul Youdelis
2019-08-15 04:38:18

Tom Franco
2019-08-15 04:38:46

Joel Mendoza
2019-08-15 04:40:20

Jön Paulson
2019-08-15 04:42:46

Darrell Schwark
2019-08-15 04:45:25

Jön Paulson
2019-08-15 04:45:32

Ty Mansfield
2019-08-15 04:50:18

Shig Bergin
2019-08-15 04:56:14

Jön Paulson
2019-08-15 04:58:18

Nick Eason
2019-08-15 05:15:09

Michael Horn
2019-08-15 06:48:26

Alex Clarke
2019-08-15 07:04:30

Jön Paulson
2019-08-15 11:25:48

Jön Paulson
2019-08-15 11:29:03

Michael Pescuma
2019-08-15 21:26:29

Mike Fatchett
2019-08-16 02:31:29

原文網址 Jön Paulson
2019-07-27 00:15:42

Here's my 1st test print of the lattice cube which is a partial failure. There's a small break towards the base and everything after that is sort of crooked and wonky, one of the anycubic text banners inside completely failed and floated into other areas of the print. There were several small pieces of the banner stuck to the inside of the lattice which broke away when I rinsed it in IPA.

I had copied the file from the stock USB to a new one but I'm not sure if it's the most recent file so I will try again with a freshly downloaded one from online. I used the default settings for the resin times with the grey rather than the green which is what I suspect caused the failure, although the initial print below the break came out very crisp. Would it simply be a matter of adjusting the exposure settings for the grey resin?

Resin was well shaken and the leveling seems to be correct based on the videos I've watched. I've strained the resin and wiped the FEP clean but noticed a pair of very small dings/dents in the surface likely from impacting with the floating artifact debris. When viewed straight on the FEP is still perfectly clear but when you hold it at an angle you can see a very slight deformation. There's no leak but is it something that I need to replace before I do further test runs?

My instinct is to switch out to the default green resin and see if I can get a successful print before changing the setting and using more of the grey. Any advice?

翻譯年糕