Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Johnathon Miller
2019-12-04 10:00:05

Hey guys and gals, I’m looking to get some different resin from the elegoo grey I have been using after I got a bad bottle of it. What are your recommendations for good resin for miniatures.

翻譯年糕

Luke Mason
2019-12-04 10:01:54

Jason Lund
2019-12-04 10:03:59

Sam Bishop
2019-12-04 10:13:31

Terry Reed
2019-12-04 10:35:28

原文網址 Johnathon Miller
2019-10-30 23:07:14

Can anybody tell me what went wrong here? I have been printing for months with no issues. The resin is super flexible and soft before curing. After curing this whole bottle has been sticky. I heard that there was a bad batch a few weeks ago but haven’t had an actual failed print yet.

Elegoo grey resin using recommended settings from the spreadsheet.

翻譯年糕

Fred Bey
2019-10-30 23:31:03

Michael Horn
2019-10-30 23:31:08

Johnathon Miller
2019-10-30 23:37:30

Benny Woolley
2019-10-30 23:43:06

Johnathon Miller
2019-10-31 00:29:11

Benny Woolley
2019-10-31 00:29:51

Mikko Asikainen
2019-10-31 01:29:02

Evan Boone
2019-10-31 06:53:57

原文網址 Johnathon Miller
2019-07-27 03:29:14

Lest nights print got stuck to the fep and pulled itself off of the supports. Would the solution to this be to modify the supports somehow? I also noticed that I didn’t tighten the big red knob down for this print.

Am I ok to try the same file but tighten things down correctly or should I reslice with better supports.

翻譯年糕

Paul West
2019-07-27 03:43:01

Stefan Giudici
2019-07-27 04:02:22

Johnathon Miller
2019-07-27 04:43:39

Johnathon Miller
2019-07-27 04:44:07

Stefan Giudici
2019-07-27 05:14:26

原文網址 Johnathon Miller
2019-07-21 12:38:07

How do you know if you have enough resin in the vat for a print? So far all I have done is miniatures and they dont seem to use much resin. I am about to start printing some larger files and I am afraid to leave it alone for an extended period of time and run out of resin. A quick google didn't answer my question.

翻譯年糕

Micah Vestal
2019-07-21 12:41:07