Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Ive been googling about and have been unable to find any specific documentation on the "lubrication" of the Z-axis on an original Photon. I have had my printer almost a year, and gone through about 15L of resin so far. (if that matters)

My most recent print completed successfully, but there was a rather audible "rubbing/rattle" after each layer was cured and the build plate moved, so i am assuming this is the issue.

I bought some silicone grease, but I am unsure the places to put it. Where the build plate meets the screw gear? Where the screw gear meets the plate where the screen sits? open the back and put it somewhere near the motor? or do i have to take the motor apart and do something there?

翻譯年糕

so, ive watched the videos on replacing the LCD screen, and i think i am pretty good with that part. MY question to the group is "how much force should i use to try and pry the glass cover from the chassis?" I am so afraid i am going to break this cover that i am reluctant to pry it too much. It seem good and stuck. It doesnt just "come off" like the videos show.

翻譯年糕