Hey guys, I got some problem with printing with Phtocentric 3D Flexible Resin.
I go with these settings on ChiTuBox 1.5.0
layer height 0.05mm
Bottom Layer 10
Exposure time 20s
Bottom Exposure time 90s
Light-off Delay 3s
Bottom Light-off Delay 3s
The best result is sticking the support to the base plate but the actual model (It's like a cap) stays on the vat...
Tried already heavy support.
Maybe use another angle?
Thanks for help
:)
翻譯年糕
Michael Pollard
2019-08-04 08:26:14
Andreas Häfner
2019-08-04 08:27:01
Ian Gill
2019-08-04 08:27:29
Michael Pollard
2019-08-04 08:27:34
Andreas Häfner
2019-08-04 08:28:41
Andreas Häfner
2019-08-04 08:29:05
Chase Wichert
2019-08-04 10:04:17
Stefan Giudici
2019-08-04 12:09:35
Olli-Pekka Salli
2019-08-04 23:38:08
Olli-Pekka Salli
2019-08-04 23:41:10
