Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi all.
I wanted to see what people thought might be the cause of what looks like a slight shift sideways during printing.

It was printed in the orientation I'm holding it in the first photo (with the build plate above it).

There's a little bit of what looks like resin clinging to some of the under hangs and I think that might be due to low temperature of the room the printer was in.
But I'm not sure what caused the big distortion.

EDIT: Added pictures of supports and settings.
Also, The resin is a mix of about 60/40 Anycubic Green and Anycubic Clear.

翻譯年糕

Does anyone know of a generic (non-chapter-specific) Space Marine Storm Shield model?
I've found a Blood Angels one and a large Inquisition themed one, but haven't found a generic one.
Thought I'd ask the community before I dive into attempting to model one myself.

翻譯年糕

Hi there. I've had my photon for a few days now, and have printed the test cube and a Sister of Battle model successfully (though too big, my fault for not checking the scale).
I had a couple of failed prints of the same object that I think we're down to having to large an area which didn't come off of the film properly.
Decided to print something else over night, and it came out mostly okay.
There is a bit of warping on the models base though.
It was printed at about 45 degrees with the cape pointing down to the bed, and using the community document for suggested exposure times, etc for Anycubic clear green resin.
Any tips on what might have happened to cause the warping, and also the visible lines every couple of mm?

翻譯年糕