Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Damien Jones
2019-11-08 22:36:59

Ok so what am i doing wrong lol. I feel like im so close but keep having this issue where the areas facing the build plate with most supports come out all messed up and blobby with extra cured resin and no detail. Parts facing into the vat are good. Been using prusa slicer mainly for supports on bigger things, Included is a couple of supports pics. Dwarf was tilted back about 10deg. Monocure rapid grey and clear both same results. Please Help!

翻譯年糕

Stuart Finesilver
2019-11-09 00:23:19

Charlie Brett
2019-11-09 00:55:43

Stuart Finesilver
2019-11-09 00:58:11

Sen Kun
2019-11-09 01:51:29

Damien Jones
2019-11-09 12:24:47

原文網址 Damien Jones
2019-11-01 22:29:40

Been having a hard time dialing the photon in, recent print done in Monocure rapid grey .04 layer 10 sec exposure. I feel I have a few problems going on but not 100% sure where to start. Im pretty sure the horrible finish on the areas closest to build plate is angle. But what about these layer shifts, could it be fep? Or z wobble? The parts closest to build plate don't seem to bad. Tia.

翻譯年糕

RIcardo Castillo
2019-11-01 22:34:35

Dominik Honke
2019-11-01 23:28:11

Stefan Giudici
2019-11-01 23:35:59

原文網址 Damien Jones
2019-10-23 22:50:54

First print was a success, but the detail was abit so so. Changed up some settings and second print down and I'm well pleased with this little guy.

翻譯年糕

原文網址 Damien Jones
2019-10-23 11:27:30

First ever print done and dusted. Now the fun part.

翻譯年糕

Fifa Mia
2019-10-23 11:56:05

原文網址 Damien Jones
2019-10-06 23:45:10

Looking to buy my first resin setup, Anyone know where the best deal is at the moment, Im in Australia and would like to get it pretty quick lol. Preferably with resin/feps ready to go. Also in my searching ive come across a printer marketed as a Anycubic photon but looks completely different, Anyone know if this is a "newer" model or just a knock off copy? (pic attached),

翻譯年糕