Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hey guys, I keep having this "sliced" error with all my prints like this. Am I not leveling my plate correctly? I cannot fathom how I could be doing the leveling wrong at this point. No matter what I print I have this void in my plate towards the center that always gives me these sliced results. This print was cancelled at 30% since there was no point in continuing. Settings? defective printer?

Please help its getting super frustrating.

翻譯年糕

Hey guys, Ive tried relevelling the base plate several times, I keep having variations of this issue. Any help would be greatly appreciated!

翻譯年糕

hey guys! I've been printing for about a week now and have some questions regarding inconsistency on the print-bed. I will be able to print a perfect miniature replica of the statue of Laocoon on one side of the bed, and the other produces nothing or just the very first layers. I seem to have plenty of stuff stuck to the plastic film of the tub as well. Any help would be greatly appreciated.

翻譯年糕

Hey guys!

Brand new to the 3d printing game. I have a couple of newbie questions on my prints if you dont mind:

Im seeing a lot of my prints build the first base plate, and then subsequent layers, nothing.

Warping where the bottom layers droop

If I print multiples of the same item, two might be perfect and two come out warped or partially printed. They are identical with the same supports etc?

Ive attached some pictures for reference. I appreciate any help!

Bobbi

翻譯年糕