Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Michael Schmidt
2019-08-12 00:41:05

Does anyone here have experience with disabling the internal fan on the Photon? I read somewhere that there's a gcode file that can be sent (somehow) to disable it, and that it's only used for fume extraction from the build area and not for cooling of any kind. Can anyone comment on their own experience?

翻譯年糕

Jarrod Smith
2019-08-12 00:55:30

Michael Schmidt
2019-08-12 00:58:15

Jared Zadorozny
2019-08-14 01:26:15

Jared Zadorozny
2019-08-14 01:28:29

Jared Zadorozny
2019-08-14 01:28:37

Jarrod Smith
2019-08-14 04:37:20

Jarrod Smith
2019-08-14 04:41:03

Jared Zadorozny
2019-08-14 05:28:32

原文網址 Michael Schmidt
2019-08-11 22:53:40

Is there a way to delete a single layer from a .photon file? I sliced a model that was supposed to be "supportless" but there's some noise on the first layer that makes the second layer almost entirely island. I've deleted the pixels on the first layer, but haven't found a way to shift the subsequent layers down.

Thoughts?

翻譯年糕

David Nicholls
2019-08-12 01:11:38

Ben Cox
2019-08-13 23:02:25

Michael Schmidt
2019-08-14 01:09:11

原文網址 Michael Schmidt
2019-08-07 07:12:56

Looking for some orientation/support advice in general. Brand new owner, test lattice cube came out beautifully, went on to print the attached figure from hero forge. I spent the better part of 2 hours trying and retrying different support structures and orientations. Best I got was 30 small islands (as detected by Photon File Validator) that were in too small places to fit supports. What's the solution here?

Should I have gone into Blender and manually stretched some things to make them work?

I also am not sure what happened to the one side of the crossbow.

翻譯年糕