Dear colleagues, I need to clear a doubt about the post-curing process of this resin that its impression was excellent, at the end it is completely translucent but when doing the post-cure it takes that yellowish tone and is not translucent. Post-curing has been done with alcohol and ultrasound washing (at different times and intensities) also with only water, dried with air and placed in the light of 405 nm also at different times, 5,10,15,30 minutes and the result is always the same .... the hardness and other characteristics are not altered ..... Does anyone have another post-cure protocol so that this does not happen? Thank you.
翻譯年糕
Casey R Marquardt
2019-08-11 22:34:07
Mike Dargan
2019-08-11 22:35:33
Ulrich Nieuwenhuis
2019-08-11 23:49:43
Saulo H. Roa Cornejo
2019-08-12 00:22:18
Lester JW
2019-08-12 02:32:59
Richard Webb
2019-08-12 02:55:33
Caleb Custer
2019-08-12 06:40:08
Albert Malaga
2019-08-12 07:52:35
Kyle A. Wolfe
2019-08-12 13:46:54
Jared Zadorozny
2019-08-13 01:55:23
