Hey guys - I have a Photon-S and I suspect the software is totally borking my prints. The supports I place are printing out very well except for a few near the center of the build where it straight up turns into a solid pillar - Which ruins the mini in question. I've moved it across the build plate and it always ends up the same (also cycled power). Unfortunately due to it being a Photon-S, the filetypes are different and there is a limited selection of software available to figure out WTF is going on. Has anyone else had similar problems before?
翻譯年糕
Jari Ivanoff
2019-09-03 23:17:00
Edgar Tudela
2019-09-03 23:19:40
Christian Whiting
2019-09-03 23:26:39
Christian Whiting
2019-09-03 23:27:25
Christian Whiting
2019-09-03 23:27:57
Edgar Tudela
2019-09-04 00:20:58
Christian Whiting
2019-09-04 01:12:11
Christian Whiting
2019-09-04 03:44:57
Christian Whiting
2019-09-04 03:45:16
Christian Whiting
2019-09-04 03:45:34
Christian Whiting
2019-09-04 03:45:52
Christian Whiting
2019-09-04 03:47:14
Edgar Tudela
2019-09-04 06:01:17
Christian Whiting
2019-09-04 06:46:26
Christian Whiting
2019-09-04 07:00:13
Edgar Tudela
2019-09-04 15:16:16
Christian Whiting
2019-09-05 02:44:39
Edgar Tudela
2019-09-05 04:11:39
Christian Whiting
2019-09-06 00:00:17
Christian Whiting
2019-09-06 00:01:04
Christian Whiting
2019-09-06 10:38:44
Christian Whiting
2019-09-06 10:39:09
Christian Whiting
2019-09-06 10:39:25
Christian Whiting
2019-09-06 10:39:36
Christian Whiting
2019-09-06 10:39:50
Christian Whiting
2019-09-06 10:41:02
Christian Whiting
2019-09-06 10:44:37
Edgar Tudela
2019-09-06 17:21:38
Christian Whiting
2019-09-07 03:30:09
Christian Whiting
2019-09-07 03:31:33
Christian Whiting
2019-09-07 03:38:36
