Hello,
a week ago I bought a Photon S and already printed some nice things.
But I have a problem with the slicer software. I am using the software from Anycubic (Photon_WorkShop_V2.0.23_Basic_Edition) and my Photon S has firmware.
When I slice the finished stl file, it sometimes happens that the Photon software suddenly closes. This always happens when the generated file gets quite big. It seems that this problem always occurs when the generated pws file becomes larger than one GB. The largest file I could create was about 1 GB. This is especially the case when I use layer thicknes=0.01 (then the file becomes big). For smaller models this also works.
Does someone else have the same problem?
With the old slicer software the photons files are much smaller, but my photon can't read them.
So I wanted to ask if you can downgrade firmware?
Thank you,
Andy
翻譯年糕
John Leonard
2019-08-18 21:29:08
Andreas Ganzer
2019-08-18 22:57:51
Andreas Ganzer
2019-08-18 23:19:31
Andreas Ganzer
2019-08-18 23:19:35
John Leonard
2019-08-18 23:23:11
Andreas Ganzer
2019-08-18 23:25:51
Andreas Ganzer
2019-08-18 23:25:56
Andreas Ganzer
2019-08-18 23:26:35
John Leonard
2019-08-18 23:28:04
Andreas Ganzer
2019-08-18 23:28:41
John Leonard
2019-08-18 23:34:01
John Leonard
2019-08-18 23:36:42
Andreas Ganzer
2019-08-18 23:38:17
Andreas Ganzer
2019-08-18 23:39:33
John Leonard
2019-08-18 23:41:56
John Leonard
2019-08-18 23:44:54
Andreas Ganzer
2019-08-18 23:45:10
John Leonard
2019-08-18 23:45:19
John Leonard
2019-08-18 23:45:43
John Leonard
2019-08-18 23:51:38
Andreas Ganzer
2019-08-18 23:52:26
John Leonard
2019-08-19 00:02:24
Andreas Ganzer
2019-08-19 00:04:28
