So I got my first resin printer, very exited, assembled it, followed the anycubic youtube guide, started my first print...nothing.
Theres no cured resin in the tank, so its not a case of the print not sticking to the bed, and theres not even anything on the build plate, so its not started and then failed, which is odd.
I did the UV light test to make sure it was working as part of set up and it was working, so very unsure as to what it could be.
any help for a total newb would be AMAZING.
tia
翻譯年糕
Gavin Starkey
2019-08-26 01:42:03
Nathan Prenovost
2019-08-26 01:49:09
Alex Vee
2019-08-26 01:51:59
Alex Vee
2019-08-26 01:52:57
Tom Barnes
2019-08-26 01:54:43
Alex Vee
2019-08-26 01:59:23
Tom Barnes
2019-08-26 02:09:56
Allan Jarnagin
2019-08-26 03:08:56
Alex Vee
2019-08-26 03:18:29
Alex Vee
2019-08-26 03:18:45
Allan Jarnagin
2019-08-26 03:19:41
Stefan Giudici
2019-08-26 04:09:14
Tom Barnes
2019-08-26 04:09:20
Tom Barnes
2019-08-26 04:10:14
Tom Barnes
2019-08-26 04:12:30
Chad Elstad
2019-08-26 04:18:18
Chad Elstad
2019-08-26 04:18:36
Chad Elstad
2019-08-26 04:19:30
Chad Elstad
2019-08-26 04:21:26
Alex Vee
2019-08-26 05:38:36
Alex Vee
2019-08-26 05:40:06
Alex Vee
2019-08-26 05:40:27
Tom Barnes
2019-08-26 06:38:54
Milton Maxson
2019-08-26 10:01:06
Tom Barnes
2019-08-26 17:02:21
Tom Barnes
2019-08-26 17:32:33
Alex Vee
2019-08-26 17:54:39
Alex Vee
2019-08-26 17:55:20
Tom Barnes
2019-08-26 17:58:56
Tom Barnes
2019-08-26 19:47:07
Alex Vee
2019-08-26 20:13:15
Tom Barnes
2019-08-26 20:37:42
Chad Elstad
2019-08-26 23:09:24
Tom Barnes
2019-08-27 17:57:38
Sen Kun
2019-08-27 21:16:50
Tom Barnes
2019-08-27 22:34:36
Tom Barnes
2019-08-27 23:28:54
Alex Vee
2019-08-27 23:44:43
Tom Barnes
2019-08-27 23:45:46
Tom Barnes
2019-08-27 23:54:05
Tom Barnes
2019-08-27 23:54:35
Tom Barnes
2019-08-28 00:04:46
