Hello, I tried to print this piece as the attached photos, but every time the piece sticks to the FEP film after about 10 layers. The resolution is 0.05. If I try to print it without support, the print succeeds but the piece can't be used because of elephant foot.
Anyone can help me? Model dimensions: 18x25xh15 mm
翻譯年糕
Mika Egger
2019-08-31 14:56:21
Pablo Prades Gutierrez
2019-08-31 14:58:21
Salvatore Battaglia
2019-08-31 14:58:56
Eric Garcia
2019-08-31 15:06:15
Spike Walker
2019-08-31 15:17:48
Spike Walker
2019-08-31 15:19:06
Spike Walker
2019-08-31 15:19:58
Justin Cupitt
2019-08-31 15:24:53
Richard Humble
2019-08-31 15:28:17
Richard Humble
2019-08-31 15:29:01
Richard Humble
2019-08-31 15:29:54
Spike Walker
2019-08-31 15:29:59
Bryan Maenz
2019-08-31 16:21:47
Spike Walker
2019-08-31 16:27:46
Niall Forrester
2019-08-31 16:52:52
Spike Walker
2019-08-31 16:54:46
Spike Walker
2019-08-31 16:55:32
Spike Walker
2019-08-31 16:58:47
Niall Forrester
2019-08-31 17:07:36
Milton Maxson
2019-08-31 19:41:09
Spike Walker
2019-08-31 19:42:26
Milton Maxson
2019-08-31 19:47:19
Salvatore Battaglia
2019-08-31 19:51:56
Spike Walker
2019-08-31 19:54:35
Spike Walker
2019-08-31 19:54:43
Milton Maxson
2019-08-31 20:02:20
