*sigh*I just got a new printer. This is my first resin printer. The test print came out fine. Others have not and I need some help figuring out what the point of failure is. I can't figure out if it's not sticking to the plate initially or is coming off due to suction. Here is a picture of what I have after stopping the print. The flat part is stuck to the fep.
翻譯年糕
Trevor Tennison
2019-09-01 02:56:38
Alexandre Belisle
2019-09-01 03:01:16
Mark Wardle
2019-09-01 03:05:45
Matthew Wilson
2019-09-01 03:06:13
Mark Wardle
2019-09-01 03:07:30
Trevor Tennison
2019-09-01 03:07:35
Trevor Tennison
2019-09-01 03:10:51
Mark Wardle
2019-09-01 03:14:05
Matthew Wilson
2019-09-01 03:26:04
Matthew Wilson
2019-09-01 03:26:14
Matthew Wilson
2019-09-01 03:26:47
Matthew Wilson
2019-09-01 03:27:59
Matthew Wilson
2019-09-01 03:29:40
Florian Helmer
2019-09-01 03:39:24
Mark Wardle
2019-09-01 03:45:51
Matthew Wilson
2019-09-01 03:47:31
Matthew Wilson
2019-09-01 03:50:46
Florian Helmer
2019-09-01 04:20:59
George Bulte
2019-09-01 05:12:59
