Another new Anycubic Owner struggling with prints getting stuck to FEP...yes this isnt FDM!
Have tried re-levelling and adjusted slice height & increasing bottom exposure time.
Current build parameters;
Layer thickness 0.02
Normal exposure time 15s
Off time 6.5s
Bottom Exposure time 120s (getting a bit high)
Bottom layers 8
Anycubic Green Resin
Thinking of the following;
-Hollowing out (a must given its brick-like shape)
-More supports (or larger supports)
-Angled print instead of flat on the build platform.
Are these steps in the right direction?
Thanks for any advice
翻譯年糕
Nick Williams
2019-09-06 01:33:15
Tony Saunders
2019-09-06 01:33:29
Martin Sandford
2019-09-06 01:34:09
Martin Sandford
2019-09-06 01:36:40
Martin Sandford
2019-09-06 01:37:53
Sam Chappell
2019-09-06 01:38:49
Sam Chappell
2019-09-06 01:39:13
Martin Sandford
2019-09-06 01:40:41
Sam Chappell
2019-09-06 01:44:38
Michael Thomas Norval
2019-09-06 01:47:32
Travis K. Jansen
2019-09-06 01:50:49
Sam Chappell
2019-09-06 01:52:26
Travis K. Jansen
2019-09-06 01:53:09
Niall Forrester
2019-09-06 04:15:14
Simon Wilson
2019-09-06 04:37:16
Milton Maxson
2019-09-06 04:40:40
Sam Chappell
2019-09-06 05:21:28
Simon Wilson
2019-09-06 05:48:30
Tom Sargison
2019-09-06 16:36:30
Travis K. Jansen
2019-09-06 18:26:33
Jason Glavich
2019-09-06 22:03:34
Jason Glavich
2019-09-06 22:03:53
Sam Chappell
2019-09-06 22:07:14
