(EDIT:
Problem solved: the factory defaults gcode from Photonsters did the trick. Thanks everyone!)
Hi all!
?
I'm a quite new Photon user and I have a problem. I did the Photon-resin-calibration from github and after switching back to print mode this happened.
The arrow buttons are upside down and I have a feeling that the Photon is getting hot when turned on.
I updated to the latest Anycubic firmware and still have the same problem.
Any suggestions how to fix this?
翻譯年糕
Philippe Maegerman
2019-08-29 19:06:01
Mika Egger
2019-08-29 19:50:49
Nathan Jantz
2019-08-29 19:51:30
Tomas Salo
2019-08-29 19:52:25
Vinicius Silva
2019-08-29 21:13:19
Maria Sohn
2019-08-30 00:33:06
Maria Sohn
2019-08-30 00:35:18
Maria Sohn
2019-08-30 00:36:52
Maria Sohn
2019-08-30 03:13:35
Vinicius Silva
2019-08-30 03:53:53
Maria Sohn
2019-08-30 04:09:27
Keegan Bradford
2019-08-30 10:27:15
Maria Sohn
2019-08-30 13:39:04
Itai M Lustgarten
2019-09-02 19:38:36
