Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Stephen Brewer
2019-09-10 09:39:05

Ugh. My print is going to fail, I noticed there wasn't any sort of raft. Supports in ChiTuBox, had a raft, saved the project, and after over an hour of adding supports...sliced, cleaned up islands, went to add more supports and it added them outside the raft. So, I deleted said raft (wasn't thinking) and now....I don't know how to add one again, aside from adding all the supports again. ChiTuBox is really frustrating.

翻譯年糕

Jeffrey Kellum
2019-09-10 09:41:10

Stephen Brewer
2019-09-10 09:51:37

Travis K. Jansen
2019-09-10 10:24:00

原文網址 Stephen Brewer
2019-09-07 23:08:14

If you are adding supports, and you see a really small island (the start of an detail, like a skull, that the next layer is attached and is really close by), do you support it? Or count on it being so small and close that'll it'll fuse to the model nearby? I've been supporting them, and I'm about to print, but there's just so many.

翻譯年糕

Chad Elstad
2019-09-07 23:24:05

Michael Horn
2019-09-07 23:24:27

Florian Helmer
2019-09-07 23:30:51

原文網址 Stephen Brewer
2019-09-06 19:41:29

Really happy with how this turned out. A couple of mistakes, and possibly too many supports (or maybe not, hah) but it didn't fail. Now to figure out how to support this giant bat...

翻譯年糕