Preparing some stl's for print when my anycubic gets here on Thursday. I've never printed in resin before and had a few questions. These are all in regards to 15mm miniatures.
Should I hollow the the model in meshmixer or chitubox?
Should I generate supports in meshmixer or chitubox.
Do I filter the resin after each print, as in empty the reservoir through a filter back into the bottle and fill it back up.
Can anyone one point me to a good series on youtube for basic use and maintenance of the anycubic photon.
翻譯年糕
Brandon Taylor
2019-09-03 02:46:40
David J Hayes
2019-09-03 02:47:08
David J Hayes
2019-09-03 02:48:18
Brandon Taylor
2019-09-03 02:48:19
Brandon Taylor
2019-09-03 02:49:34
David J Hayes
2019-09-03 02:49:50
Brandon Taylor
2019-09-03 02:50:10
Brandon Taylor
2019-09-03 02:50:33
Brandon Taylor
2019-09-03 02:51:40
David J Hayes
2019-09-03 02:52:47
Brandon Taylor
2019-09-03 02:54:09
Ian Gill
2019-09-03 07:00:20
Ian Gill
2019-09-03 07:02:09
Brandon Taylor
2019-09-03 08:26:46
Mike McCreery
2019-09-03 08:34:19
