Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Jim Wolfe
2019-10-06 07:23:01

So I just replaced my LCD screen and I tried to do the UV light test and it only comes on for about a second and besides the purple square the outside frame there are longer lines on the outside any ideas? Bad LCD screen?

翻譯年糕

Muhammad Zulkhairol Yacob
2019-10-06 07:30:02

Jim Wolfe
2019-10-06 07:37:50

Tim Moulton
2019-10-06 10:54:39

Jay Jones
2019-10-10 19:18:45

Jim Wolfe
2019-10-10 21:11:39

原文網址 Jim Wolfe
2019-09-22 09:39:29

Hey All, I just did a bigger print of a mini (x225%) and i have a few hole going directly thru my print. Has this happened to any one and what might have caused it. I did a full clean of the Vat before i ran this print.

翻譯年糕

Elle Heilig
2019-09-22 09:40:59

Elle Heilig
2019-09-22 09:41:30

Tiernan Messmer
2019-09-22 09:43:31

Jim Wolfe
2019-09-22 09:44:04

Jim Wolfe
2019-09-22 09:44:47

Elle Heilig
2019-09-22 09:47:20

Jim Wolfe
2019-09-22 09:49:15

Tiernan Messmer
2019-09-22 09:51:24

Jim Wolfe
2019-09-22 09:53:40

Phil Davidson
2019-09-22 10:37:36

Ben Cox
2019-09-22 11:01:06

Elle Heilig
2019-09-22 11:04:27

James Munsterman
2019-09-22 11:15:38

James Munsterman
2019-09-22 11:16:14

Stephen Lewis
2019-09-22 13:50:18

Jim Wolfe
2019-09-23 05:53:54

Susan Sioux Mercer
2019-09-23 07:41:32

Jim Wolfe
2019-09-23 07:42:28

原文網址 Jim Wolfe
2019-09-14 03:20:50

Hey All, I have a question i just started using ELEGOO ABS-Like 3D Printer Rapid Resin LCD UV-Curing Resin 405nm Standard Photopolymer Resin for LCD 3D Printing 1000Gram Grey off Amazon. After i soak it in 99% IPA for about 10 mins and then go over it with a soft toothbrush and re-dip a couple more time and go over it with the tooth brush again, then i have been curing it under a UV LED nail dryer for 20-30 mins. Is that the proper procedure? The Elegoo feels rubbery is that how it's suppose to feel? I like the detail and am happy with the outcome i just want to make sure i'd finishing the procedure? Thanks to all that can help me with this.

翻譯年糕

Melecio Guzman
2019-09-14 05:41:46

原文網址 Jim Wolfe
2019-09-07 21:54:50

Hey All i have a question, my glass came off the base of the machine and won't stick. What kind of adhesive should i use on it to fix this issue? I was doing a print last night and woke up to this, part of the print was stuck on the glass thru the vat.Cleaned it up and that is when the glass came up. Thanks for any help.

翻譯年糕