hi, i have a question how to handle the water after cleaning the model.
first I wash my model with ipa, which I exposure to sun and collect back in plastic bottles for disposal.
secondly I wash the model with warm soap water to get the ipa off. How I have to handle this water? collect it or can I flush it in the toilet?
thanks, Peter
翻譯年糕
Gregory Akin
2020-03-24 00:59:33
Cure the water and strain it a few times.
Laurence Camley
2020-03-24 01:00:24
I would put the water in a clear bottle, leave it out in the sun somewhere safe then pass it through a coffee filter before pouring it down the drain. Theres enough plastic in the water ways as it is.
Oleksandr Panforov
2020-03-24 01:03:48
Do not flush it, that's for sure. Most resins are a disaster for the environment.
My flow is the following: cure used IPA and water, filter the cured resin, and then re-use or, if unusable - leave near the sunny window till evaporates.
Stefan Giudici
2020-03-24 01:13:36
There's no need to use water in the first place
Stefan Giudici
2020-03-24 01:13:57
It causes more harm than good. Ipa, then cleaner Ipa, done.
Pete Kastner
2020-03-24 01:29:30
Re uses your IPA as well.
Peter Neumnn
2020-03-24 01:58:21
thank you for the advices
:)
