Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Ian Jones
2019-10-05 03:36:31

I am trying to run the exposure calibration test from photonsters, but when I put the files onto the USB, the test-mode.gcode doesn't show up on the printer. The print-mode one does. Running FW 4.2.19. Anyone have any hints to point me in the right direction please?

翻譯年糕

Chris Cassaday
2019-10-05 03:38:50

Ian Jones
2019-10-05 03:40:51

Mario Hippmann
2019-10-05 03:49:23

Piotr Sych
2019-10-05 03:56:05

Ian Jones
2019-10-05 03:58:47

Piotr Sych
2019-10-05 04:01:16

Piotr Sych
2019-10-05 04:16:02

Ian Jones
2019-10-05 04:17:54

Piotr Sych
2019-10-05 04:21:38

Falcon Tom
2019-10-30 00:37:13

原文網址 Ian Jones
2019-09-26 18:28:22

Hey all, my FEP has started sticking to the screen. It all seems clean, but just puts up a bit of resistance if I pull the bath out. Do I need to change my FEP or will it be ok?

翻譯年糕

Joel Dawson
2019-09-26 18:31:04

Manuel Galán
2019-09-26 18:31:33

Ian Jones
2019-09-26 18:34:47

Chad Elstad
2019-09-26 19:59:30

原文網址 Ian Jones
2019-09-11 02:17:27

Hi all, wondering if someone could help a relative newbie out! Been printing fine constantly in the few weeks I have had my Photon, but had the same issue three times now. Printing 4 identical parts in one job, 2 came out perfectly, and 2 came out like the attached. The circled parts are what should not be there. In each case, the parts that had the issue were closest to the front of the machine.

After the second failure, I drained the resin out, relevelled the bed (it was high at the back it turned out) and set another job going. Exactly the same issue.

Using standard anycubic clear resin. Pictures in the comments for what the part should look like.

Thanks in advance!

翻譯年糕