Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Adam Fabio
2019-09-15 02:59:13

I bought a bottle of elegoo rapid Grey, and my prints seem to stay tacky no matter how much I cure them. One question - the date on the bottle is July 2019. Is that a bottle date or an expiration date? All my anycubic resin has dates into 2020.

翻譯年糕

Chad Elstad
2019-09-15 03:02:05

Evan Boone
2019-09-15 03:04:45

Adam Fabio
2019-09-15 11:03:28

原文網址 Adam Fabio
2019-08-23 04:02:30

Hi all, I've been working with this printer for over a week now, and I haven't had any luck. I've been FDM printing since 2011, but so far resin has proven to be frustrating.

So far I haven't had any successful prints. Every print gets a few layers in and sticks to the FEP. I've leveled the build plate many times using both the paper and Reed method, replaced the FEP (ensuring the film is removed)

I've disassembled, cleaned and re-assembld the build plate.

My build plate appears to have a tiny cup. I can just barely see light a steel machinists ruler is placed upon it.

I've tried to print the rook, and the birdcage From https://pinshape.com/items/23778-3d-printed-bird-cages . Both have been flat to the build plate. Should I be tilting/supporting these prints?

In addition to sticking to the FEP, I see a skin of resin around the part, and some loose partially cured resin floating in the vat. Checking the UV light and display, it looks like the patterns are being shown correctly.
I have also tried various settings, though I've only used the green which comes with the printer.
My settings for this print were:
Layer Height: 0.05
Bottom layer count: 10
Bottom Exposure Time: 80s
Regular exposure time: 15s
Light off delay: 1s
Bottom Light off Delay 5s

Everything else is standard from Chitubox.
I did run the print through the validator. It found a few island higher up the cage and repaired them.

If you look at the image showing the front of the build plate, the gap is larger on the right side. This plate is level in this photo. I'm not sure, but it looks a bit like my whole Z rail has a slight tilt - note the image showing the top of the rail. I'm not sure if I can use the shell of the printer as a reference here.

So Heeeelp - can anyone suggest what I should do to get a successful print?

翻譯年糕