Thanks in no small part to all the advice I've read in this group over the past few weeks, my first resin print attempt (60 x 60mm Mount Everest model) was a success!
Printed flat (with supports added in PrusaSlicer) in about 1.5 hours. 3 base layers at 60 seconds and other layers at 6 seconds on the Photon S.
The only issue is that it still smells like the Mr. Clean solution I used to wash it before curing. Hopefully that'll rinse out or wear off.
翻譯年糕
Smith Hayward
2019-10-04 12:10:50
Justin Leone
2019-10-04 12:53:38
Nicolas Tsagarides
2019-10-04 16:24:35
Justin Leone
2019-10-04 21:55:49
