Need the experts to chime in! The Test Cube printed beautifully (except for the idiot who broke the base off while removing it from the build plate) so I decided to go all-in with the second print. I couldn’t be happier with the print quality, but as you can see, I have a droopy apron. I’ve done enough reading to have some likely suspects, but would love to have someone conform where I went wrong.
I didn’t print at an angle because the model is inherently angled in every direction, but is it possible that the warping happened while it was pulling from the FET?
Many of the supports separated from the base, which gives me a “chicken or the egg” situation, did the droop happen after it separated, or did it separate because of the droop? I used the auto support setting in ChiTu on the medium setting. I left everything else on the default setting. (I also hollowed the model out and added holes to the bottom)
My last concern is that I started the print in the early evening and let it run. It would have finished around 2am and sat until I woke up at 8. Did gravity just tug at the uncurled edges? That doesn’t seem likely, but what do I know?
Of course there may be more options out there...
翻譯年糕
Mike McCreery
2019-10-03 22:06:20
Justin Butters Sinks
2019-10-03 22:12:46
Smith Hayward
2019-10-03 22:22:34
Daniel Prows
2019-10-03 22:22:51
Herman Simpson
2019-10-03 22:51:47
Stefan Giudici
2019-10-04 01:19:44
Firdaus Zakaria
2019-10-04 09:22:42
