Hi guys, I've printed a super hero Bust for a friend.He had the model send it, i just hollowed it and printed.
I made lots of classic Errors here on this print.
Its my 3rd print
1. I Hollowed but made no escape holes thinking that it would drain out and only trapping a little bit in the head, wrong
:-)
it trapped resin everywhere.
2. Printed directly from the base, no supports no inclination
I have a lot of layers highly visible including what it looks like 2 major layer shifts
I read a lot from this forum so i will prepare the print better next time.
I thing i will hollow it better including a full hole at the base, not sure if i would make extra holes without breaking the model.
Not sure if it needs inclination and supports..
But I will hear your advice while preparing the model to print late in the day.
翻譯年糕
Dave Dewees
2019-12-30 18:18:49
Tiago Carita
2019-12-30 18:22:01
Dave Dewees
2019-12-30 18:25:59
Tiago Carita
2019-12-30 18:27:31
Tiago Carita
2019-12-30 18:58:47
John Rhodes
2019-12-30 19:24:17
John Rhodes
2019-12-30 19:24:29
John Rhodes
2019-12-30 19:24:54
John Rhodes
2019-12-30 19:24:59
John Rhodes
2019-12-30 19:25:04
John Rhodes
2019-12-30 19:25:08
John Rhodes
2019-12-30 19:25:48
John Rhodes
2019-12-30 19:26:27
Sargent Raze
2019-12-30 19:56:30
Tiago Carita
2019-12-31 02:02:25
Jesus Javier Pulido Medina
2019-12-31 06:49:35
John Rhodes
2019-12-31 07:42:30
John Rhodes
2019-12-31 07:43:03
John Rhodes
2019-12-31 07:43:46
Tiago Carita
2019-12-31 08:33:31
John Rhodes
2019-12-31 11:02:47
Артем Головичев
2020-01-01 22:55:15
