Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Matthew Tan
2019-10-05 06:14:47

Hello again, so after my last 2 failed prints which I'm still not sure what went wrong.

I decided to just print a very simple cube just to test. Just wondering now is what I'm seeing on the top part of the print Z Wobble?

I'm using a Photon S, But the print didn't fail so that's a step forward.

Some of the side parts are messed up because I picked it up before it was cured.

Thanks again

翻譯年糕

Mark Wardle
2019-10-05 06:24:24

Ian Roth
2019-10-05 06:26:09

Matthew Tan
2019-10-05 06:27:52

Mark Wardle
2019-10-05 06:35:53

Mark Wardle
2019-10-05 06:36:03

Matthew Tan
2019-10-05 06:36:54

Mark Wardle
2019-10-05 06:37:08

Caio Donini
2019-10-05 06:37:45

Matthew Tan
2019-10-05 06:38:33

Mark Wardle
2019-10-05 06:38:43

Mark Wardle
2019-10-05 06:38:59

Matthew Tan
2019-10-05 06:40:03

Mark Wardle
2019-10-05 06:40:20

Mark Wardle
2019-10-05 06:40:40

Mark Wardle
2019-10-05 06:42:03

Matthew Tan
2019-10-05 06:42:29

Mark Wardle
2019-10-05 06:43:01

Mark Wardle
2019-10-05 06:43:29

Matthew Tan
2019-10-05 06:44:14

Mark Wardle
2019-10-05 06:48:06

Mark Wardle
2019-10-05 06:48:34

Mark Wardle
2019-10-05 06:50:04

Matthew Tan
2019-10-05 06:54:42

Mark Wardle
2019-10-05 07:14:13

Mark Wardle
2019-10-05 07:14:27

Mark Wardle
2019-10-05 07:14:45

原文網址 Matthew Tan
2019-10-01 17:40:17

Sorry for the long post.

I finally got my Photon S and tried to do my first two prints which both failed(Cube).

I'll post the pictures and try to maybe say what I think they could be. I don't have experience with 3D Printing and know I will only learn by doing and making the mistakes.

*** 1st Print ***
I think maybe what happened here was from me not shielding the printer from the sun well enough. It wasn't in direct sunlight but enough maybe bounced around and in.

Also when I was cleaning the FEP after this I noticed a really thin layer which I thought was resin but could be that protective layer that new FEP films come with.

When I first poured the resin I did shake it quite hard so there was quite a lot of bubbles so maybe a bubble in the wrong place?

*** 2nd Print ***
So this one almost came out right except for what you can see. Not too sure what happened here I covered the printer with the box it came with, But I did sneak a couple of peeks here and there.

I shook the bottle a bit less this time and there were still a bit of bubbles but not as much as the first time.

Not too sure what I could do. I just straight plugged in the USB and tried to print didn't tweak any settings. Maybe I need to level the bed again?

Thanks again everyone

翻譯年糕