In need of help please.
I have a photon S. I have no issue at all printing the RERF file pre sliced by anycubic, which leads me to believe that the level and tension of the FEP are good.
When I slice a file (using the anycubic software in default) the file doesn’t stick at all to the plate. I do not know what to do, I think it must be setting that is causing the fault.
On an interesting side note, I was looking at the settings of the RERF file and it payed the first layer, then I printed my file and it printed well ..
So I am confused
Wade
翻譯年糕
Philip Coulson
2020-02-05 12:40:03
Denis Wade
2020-02-05 12:44:31
Philip Coulson
2020-02-05 12:45:42
Denis Wade
2020-02-05 12:45:55
Denis Wade
2020-02-05 12:46:06
Philip Coulson
2020-02-05 12:47:14
Denis Wade
2020-02-05 12:48:09
Philip Coulson
2020-02-05 12:48:34
Denis Wade
2020-02-05 12:49:22
Denis Wade
2020-02-05 12:49:46
Philip Coulson
2020-02-05 12:50:12
Denis Wade
2020-02-05 12:50:50
Philip Coulson
2020-02-05 12:51:59
Denis Wade
2020-02-05 13:55:24
Philip Coulson
2020-02-05 14:02:59
Denis Wade
2020-02-05 14:32:21
Philip Coulson
2020-02-05 15:03:11
Denis Wade
2020-02-05 16:11:03
