Hey everyone, new to the group
?
Couldn’t help my excitement, had to show off the 1st print. Had 1x failed attempt at the lattice cube test print on the USB, but wasn’t using the AnyCubic resin so guessing that or my level was the cause of error.
Adjusted settings in ChiTubox, releveled.... Boom
?
a rook from a rookie
翻譯年糕
Rhiannon Beorn Van D
2019-10-12 18:17:27
Nicholas Callow
2019-10-12 18:20:56
John Baker
2019-10-12 18:24:56
John Baker
2019-10-12 18:25:43
Nicholas Callow
2019-10-12 18:25:52
Alex Vee
2019-10-12 18:35:54
Ash Fielding
2019-10-12 20:46:50
John Baker
2019-10-12 21:43:07
Ash Fielding
2019-10-12 21:44:31
