Getting super frustrated by this. Gone through ~250ml and really only have one print I can say was good. Any ideas? I'm using Anycubic Translucent Green. I'm using the settings from the Google doc for, but I have supports that crash, or models that never stick to the plate? Not sure what all the white stuff on the prints are after I clean them? I'm assuming its the IPA (91%). I did the Flint Read method which at least got them to sorta stick to the plate. I printed the sample files and you can see it broke apart, sections where stuck to the bottom of the vat.
翻譯年糕
Daniel Randle
2019-10-15 10:57:14
Steven Raybell
2019-10-15 10:58:03
Dave Weiss
2019-10-15 10:58:57
Lee Baxter
2019-10-15 10:59:25
Dave Weiss
2019-10-15 10:59:54
Dave Weiss
2019-10-15 11:00:49
Stefan Giudici
2019-10-15 11:02:14
Dave Weiss
2019-10-15 11:11:19
Dave Weiss
2019-10-15 11:12:10
Dave Weiss
2019-10-15 11:13:50
Hector Alvarez
2019-10-15 11:20:03
Hector Alvarez
2019-10-15 11:24:45
Stefan Giudici
2019-10-15 11:31:53
Dave Weiss
2019-10-15 11:52:55
Ioan Flerr
2019-10-15 18:51:22
Kevin Lems
2019-10-15 20:51:01
Paul West
2019-10-16 03:29:20
