So I've had my Photon about a week now. Had the usual issues around bed leveling and supports etc. But after delving through the forums and got hub seemed I had everything worked out. Printed so impressive prints (long time fdm fan boy).
But the I started getting memory card errors, so got a new usb as github states. Also checked to make sure the usb inside the machine was connected it was. But now I'm getting all sorts of issues with it. From 1% restarts and freezes and then reboots memory issues and restarts after I move the z up...
I was expecting some teething issues but not as many as all of these is such a short space of time. I've attached a video.
Advice greatly appreciated.
Oh I also updated the firmware to the latest version to see if that helped. (It did not)
翻譯年糕
Dylan Sawatzky
2019-10-23 02:28:35
Chris Marks
2019-10-23 02:30:03
Dylan Sawatzky
2019-10-23 02:33:14
Jeff Greenfield
2019-10-23 09:14:19
