Hello everyone!
I've had my photon for about a week now and I'm having a blast learning, failing and testing! Been trying some of my own design the past few days and its loads of fun!
Overall I'm improving print per print but I'm just curious, the crystal skull got a white "frosting" on some parts after cleanup, or maybe it was even there right from the start.
I am cleaning using an ultrasonic cleaner filled with some all purpose cleaner and a dash of iso. Then I dunk them into a bath of iso for a few minutes and agitate little.
Finally I dunk them into a bath of deionized water and then a cure under a nail polish UV dome.
I am using the Anycubic eco resin.
Any ideas or tips are appreciated!
Thanks in advance!
翻譯年糕
Phillip Kenney
2019-10-25 07:11:00
Simon Barle
2019-10-25 07:13:03
Phillip Kenney
2019-10-25 07:13:42
Simon Barle
2019-10-25 07:20:34
Steven Howland
2019-10-25 07:29:09
Simon Barle
2019-10-25 07:44:08
Steven Howland
2019-10-25 07:49:33
Steven Howland
2019-10-25 07:49:39
John Chrapkowski
2019-10-25 12:22:14
Nipuna Gunarathne
2019-10-25 18:05:54
Simon Barle
2019-10-25 18:07:30
Adam Christman
2019-10-29 03:24:59
