Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Ed Horn
2020-01-24 12:32:57

So guys what ya think Led going bad or motherboard...or something else. Anyone run into this before?

翻譯年糕

Branden Voss
2020-01-24 12:34:02

Stephen Gilbertson
2020-01-24 12:36:48

Stephen Gilbertson
2020-01-24 12:38:10

Stefan Giudici
2020-01-24 12:59:24

Ed Horn
2020-01-24 13:21:27

Ed Horn
2020-01-24 13:37:36

Stefan Giudici
2020-01-24 14:25:49

Tommy Huwa
2020-01-24 15:47:22

Ed Horn
2020-01-25 21:54:23

Ed Horn
2020-01-25 21:54:40

Veda Toys
2020-01-26 22:18:56

Ed Horn
2020-01-27 12:09:38

原文網址 Ed Horn
2019-12-04 00:07:25

Hey folks i have a question, I am having a couple issues with my photon and need some advice. One getting a flickering on half of the test rectangle sometimes and i am getting a buzzing sound sometimes when i turn the printer on but when i turn it off and on again i get the normal startup and running sounds that the printer normally makes. I am thinking a fan issue but am not sure. I am running version 4.2.19.3 and Anycubic tec support says to install version 4.2.12. Now i may not be the smartest guy in the world but this looks to me like an earlier firm ware version. Any thoughts on this? Should i install this version? What say you? Thanks in advance.

翻譯年糕

原文網址 Ed Horn
2019-11-28 08:19:25

I have a question why do you need to relevel the build plate after replacing the FEP? If it was level before you changed the fep what conditions would have changed that make it necessary to relevel? I mean I know it's not such a time-consuming thing to relevel the plate I was just curious as to why other than using the Flint read method why is necessary to relevel?

翻譯年糕

Scott Schwoppe
2019-11-28 08:23:54