Tried 3 prints of these “coins” in the past few days and very little success. New to SLA - Photon S with anycubic green.
Posting now without complete info as I finally have a chance to. The first two tries were with 3 rows of 4 “coins.”
Then switched to 8 layer start with 65s exposure and 12s for normal layers. Got 2/12 of the coins ok. Then tried with only 9 coins in the design and was worse.
Tied both methods of adjusting plate and settin “0.”
Please any advice welcome!
翻譯年糕
DJ Brookshire
2019-10-30 14:04:01
DJ Brookshire
2019-10-30 14:04:41
Jon Quirós
2019-10-30 20:24:12
DJ Brookshire
2019-10-30 20:25:39
Jon Quirós
2019-10-30 20:45:12
DJ Brookshire
2019-10-30 20:48:14
