Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Chris Wallace
2019-11-29 11:19:12

What is the maximum temperature Grey resin can withstand when its fully cured. Looking to use it to make molds for injection molding some parts

翻譯年糕

Matt Reed
2019-11-29 11:20:44

Chris Wallace
2019-11-29 11:22:20

原文網址 Chris Wallace
2019-11-19 13:55:43

So after an hour printing it came out fine , soaked it in 91% for a couple seconds then put under UV curer for 120 seconds and now I get this white looking powder

翻譯年糕

Justin Coles
2019-11-19 13:57:40

Tynbendad Dadtynben
2019-11-19 13:58:14

Chris Wallace
2019-11-19 13:59:21

Jesse Mouré
2019-11-19 13:59:40

Chris Wallace
2019-11-19 14:00:31

Justin Coles
2019-11-19 14:04:08

Andrew Springer
2019-11-19 14:22:04

Evan Boone
2019-11-19 14:44:43

Paul Churchill
2019-11-19 15:36:45

Joel Reid
2019-11-19 15:39:23

Brian Corbin
2019-11-20 05:25:09

Tynbendad Dadtynben
2019-11-20 08:35:09

Jaco Norchie Nortje
2019-11-20 12:59:28

Coolbetty Cakes
2019-11-21 03:43:31

Joe Cahill
2019-11-21 08:25:38

Robert Hamberger
2019-11-21 23:03:58

Dave Dewees
2019-11-22 09:01:31

原文網址 Chris Wallace
2019-11-05 08:47:20

Hello All!

I recently purchased the Anycubic Photon. I currently used Autodesk 3DS Max for my design software. I am trying to print various parts in 1/87th scale. I use my caliper to measure the sizes and replicate them into 3DS. When I go to print, i end up getting nothing because its so small. Any tables or tricks to get things the right size for 1/87th Thanks!

翻譯年糕

Sherri Johnson
2019-11-05 08:56:35