Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Tommy Cakebread
2019-11-12 18:00:10

Decided to set recalibrate my printer since my print failed yesterday and have noticed something odd.
I set the z=0 when the paper has some friction and moves the build plate. But then if I move the build plate up about 100mm and click home it doesn't go quite as low as a set it and the paper moves freely with maybe more than 1mm to spare. Is this expected?

翻譯年糕

Simon Wilson
2019-11-12 18:03:48

Tommy Cakebread
2019-11-12 18:04:19

Simon Wilson
2019-11-12 18:07:52

Tommy Cakebread
2019-11-12 18:10:00

Simon Wilson
2019-11-12 18:10:34

Simon Wilson
2019-11-12 18:13:38

原文網址 Tommy Cakebread
2019-11-12 00:30:57

Hey guys, brand new to 3d printing and just got my Photon setup and ready. Leveled the bed and tried out the test print and this was the result. It failed about 1/4 of the way in. Any suggestions on what I should do to improve? Is this a problem with the settings on the standard file for the resin I have ( anycubic translucent yellow) or is this a problem with something else?

翻譯年糕