Hey all, please forgive such a rookie post, but Ive been struggling. Ive been doing several test prints trying to find the best settings and cant seem to figure this out. Im printing a fairly simple zombie head sculpt with the attached settings. There is plenty of surface detail in the sculpt, however the prints keep coming out as a softer version of the sculpt.
I am printing on the photon s with the anycubic 405 nm SLC grey printer resin.
Am I missing some key setting to get a higher resolution out of my printer? All other sculpts seem to be much high fidelity than what Im getting. Even my support structures seem a little soft (visually), not as hard edge as expected.
Any help would be greatly appreciated, thank you!
翻譯年糕
Tomasz Biłas
2019-11-16 16:45:09
Stefan Giudici
2019-11-16 16:46:25
Pa Wel
2019-11-16 16:48:25
Tomasz Biłas
2019-11-16 16:48:52
Jonathan Lindblom
2019-11-16 16:50:07
Ernest Dam
2019-11-16 16:50:29
Jonathan Lindblom
2019-11-16 16:50:33
Pa Wel
2019-11-16 16:51:11
Stefan Giudici
2019-11-16 16:51:32
Jonathan Lindblom
2019-11-16 16:51:54
Ernest Dam
2019-11-16 16:53:33
Jonathan Lindblom
2019-11-16 16:54:05
Jonathan Lindblom
2019-11-16 16:54:13
Jonathan Lindblom
2019-11-16 16:54:23
Ernest Dam
2019-11-16 16:58:26
Cam Erasmus
2019-11-16 16:59:53
Jonathan Lindblom
2019-11-16 17:08:00
Jonathan Lindblom
2019-11-16 17:08:39
Tomasz Biłas
2019-11-16 17:13:40
Ernest Dam
2019-11-16 18:36:42
Felipe Carascosa Ferro
2019-11-17 06:12:24
