Hello all! I am enjoying reading and learning for all of you.
I have a recent issue. I have a mini model of a Orc with a battleaxe I am trying to print. It will only print solid from the base to the platen in the printer. If I print it upright, then the base and supports are about 8mm (1/3 inch) thick.
If I print its tilted back, then there are a few supports at the edge, but when it prints, then it again prints the base solid to the platen. (See pictures below).
Anyone know why this is happening?
翻譯年糕
Danny Freed
2019-11-25 08:01:37
David Christie
2019-11-25 12:51:46
David Christie
2019-11-25 12:52:21
