Another issue that's probably been solved a million times already:
First time needing to replace FEP (original finally started leaking), so I replaced it, and recalibrated home/leveled the print plate. I used the paper method to level.
I used a print file that has been 100% successful in the past, but while one side printed perfectly, the other half stuck to the FEP.
Now! I have had vat-sticking previously, but it had always been support issues, not leveling or exposure settings, so I'm concerned that I messed up the FEP install somehow.
Should I just attempt to level the plate again and hope I don't keep sticking, or is there a way to make sure the vat isn't interfering somehow?
翻譯年糕
Michael Tetreau
2019-12-09 07:27:04
Katherine Hubis
2019-12-09 07:33:05
Katherine Hubis
2019-12-09 07:33:15
Michael Tetreau
2019-12-09 07:36:12
Alexander Keith
2019-12-09 07:41:22
Katherine Hubis
2019-12-09 07:41:26
Katherine Hubis
2019-12-09 07:42:40
Katherine Hubis
2019-12-09 07:46:05
Alexander Keith
2019-12-09 08:16:55
Katherine Hubis
2019-12-09 11:26:18
Jose Sicairos
2019-12-09 19:08:45
