Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Does time between the print finishing and it getting cleaned/cured impact the finished quality of a print?

For example if a print finishes during the night and sits in the printer for hours until getting cleaned, or if it finishes after the sun goes down, gets cleaned but waits for the next morning to cure in the sun.. is there any negative impact from either of these scenarios?

翻譯年糕

Hi Guys, Recently got the photon S and thanks to some helpful people here got a successful print of the test file from anycubic.

I've gone to print my first file, added supports etc and thought I was ready to print.

However as soon as I plug a USB with the file into the printer the touchscreen becomes non-responsive, not even recovering if the USB is removed. I delete the file off the USB and it doesn't freeze the photon when plugged in again.

I tthought it might be the crappy included USB so tried another USB without any success either.

My process for preparing the file had been:
1)auto orient and supports from prusa slicer
2)import stl into chitubox to export as .photon
3)use photon validator to check for islands
4)fix islands in chitubox
5)export as photon from chitubox

When I first started getting the freezing I tried exporting from chitubox as a stl and importing into photon workshop and exporting from there as a pws but still having the same issue

翻譯年糕

Hi Guys, need a bit of a hand getting my initial test print going. as you can see in the picture it's a fair bit wobbly, but I'm not sure how to fix it, most of my googling indicates to change the exposure time, but I would have thought for the test model with the provided resin that should already be set up fairly well.

I had a previous print that failed to adhere to the build plate, but I managed to sort that by releveling it. I drained and filtered the vat, cleaned the failed print off the base of it but there was still some faint smudges even after wiping it with IPA. Could this be the cause?

The other thing I'm wondering is if the temperature here would have caused it? it was around 30 celsius in the room for most of the print with a high humidity.

Should also note it's a Photon S for any difference that makes.

翻譯年糕