Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Hanysek Rufferů
2020-03-10 15:23:30

Did all the changes but the print isnt good.

-Leveled

-Changed FEP

-After chitubox used photon file validator

-Used new USB

-Resin is about 20 Celsius, shaked

-Black anycubic resin

-One of the failures is probably unsupported areas, but what about that pieces that looks like a random piece of printed layer and then it destroys some supports or print areas.

翻譯年糕

Jacob Palmer
2020-03-10 18:35:10

Szabolcs Matefy
2020-03-11 14:50:36

Hanysek Rufferů
2020-03-11 16:47:38

Hanysek Rufferů
2020-03-11 16:54:12

原文網址 Hanysek Rufferů
2020-03-04 19:17:41

Is this just a suction problem, or it can be caused by something else. Base layers are splitted. Then it went good and then bad again.

翻譯年糕

Dominik Honke
2020-03-04 19:33:54

Jacob Palmer
2020-03-04 19:40:20

Hanysek Rufferů
2020-03-04 21:01:37

Hanysek Rufferů
2020-03-04 21:02:30

Jacob Palmer
2020-03-04 21:03:13

Hanysek Rufferů
2020-03-04 21:07:42

Hanysek Rufferů
2020-03-04 21:09:00

Jacob Palmer
2020-03-04 21:10:26

Dominik Honke
2020-03-04 21:16:22

Hanysek Rufferů
2020-03-04 22:45:34

原文網址 Hanysek Rufferů
2020-03-03 20:53:59

Hello, so after a series of succcesful prints I somehow cant get o gootd one now. Firts there were some artefacts that werent a part of the model, it was in a shape of a rectangle or square. I changed FEP and USB that iam using for print. It seem that artifacts are gone. But since then it will just stick to the FEP or split in the process of print. Firts layers are good, I recalibrate Z0 I tried add suports. Where can be the problem?

翻譯年糕

原文網址 Hanysek Rufferů
2019-11-27 19:58:25

What happen if you print intersecting geometry. Like two cubes that are two separated meshes, but part of them is intersecting. Will the printer take it and print ok or there will be errors during print?

翻譯年糕

Arjen Aka Vargen
2019-11-27 20:00:51