Well I finally bit the bulletand printed my first 3d print. As I’m visually impaired I was reluctant to do this first print before I was YouTubed up on all the latest “how too” video’s
First I did the Luke Towen selection of the Anycubic photo resin printer up front that inevitably lead me to doingthe Flint Read levelling, the 3Dprintingpro methodology of support, the physics anonymous Z access stabilisation upgrade, along with Simon Jackson for his z lead screw slope elimination upgrade.
After all that I printed my first print and it was astounding in its fidelity. Other than it swelled a little (I suspect my 12 sec exposure should be reduced to say 11 seconds). But I am blown away by the quality.
翻譯年糕
Tiernan Messmer
2019-12-01 12:09:18
Mark Stafford
2019-12-01 16:24:57
Mark Stafford
2019-12-01 16:26:17
Mark Stafford
2019-12-01 16:34:35
