Hey all! I could use some help diagnosing why I'm seeing what I'm currently calling "ghost supports" on my prints. Here's the usual info:
Anycubic Photon S: Zbrush *.stl -> Chitubox (for supports) *.stl -> Photon Workshop (for Slicing and settings, and to produce a *.pws, which is the only file type my Photon S is currently recognizing. My settings are attached.I'm using Elegoo Grey Resin, but I don't suspect this is a resin issue.
Even in my sliced files, I was noticing some strange spots that look almost like artifacting in either white or black that appear to continue up through the slices of the model, which aren't present in the support preview, but do appear to be showing up on my prints. I can see them in slicing previews from either Chitubox or Photon Workshop, and I think they may be what's showing up as extra columns of support-like structures throughout my prints (circled in red). Once they touch the main figure, they appear to stop. (ie: the LED doesn't have pixels that are simply stuck in an "on" setting)
Any help on diagnosing what they are and how to get rid of them would be very much appreciated, thanks!
翻譯年糕
Nipuna Gunarathne
2019-12-27 17:40:35
Mick Marriott
2019-12-27 17:59:47
Kymba LeCrone
2019-12-27 20:29:34
Kymba LeCrone
2019-12-27 20:30:36
