So I’m on my 3rd print ever the cube went perfectly and my 2nd print went well but today when I tried my 3rd print, the build plate lowered into the resin as usual and started the first layer. Well normally the build plate lifts up off the fep and lowers back down for the next layer but now it doesn’t even lift between layers. If you stop the print and try to manually lift the build plate it doesn’t move at all until you turn it off and turn it back on. I’m stumped. Tried to update the firmware as well but I get an error that it can’t read the type of file. I extracted the firmware files directly to the root of my thumb drive as I’ve seen. If anyone has any ideas on what’s going on it’d be greatly appreciated. Thanks.
翻譯年糕
Mike Fatchett
2019-12-11 12:32:36
Arturo Jimenez
2019-12-11 14:07:07
