Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anyone know what is happening to me in chitubox?

I have been following the method of placing supports in chitu, slicing and checking through the validator. I don't recall having a problem before. I fix any errors I can and then save the file so I can open it in chitu again and support any islands I missed. But now I am getting this. I have printed these models before, there are no unsupported islands, but if I run it back through chitu it suddenlt has hundreds of single pixels everywhere.....makes checking for actual islands rather difficult.

翻譯年糕

Hello, I have been getting pretty good prints off my photon but noticed this problem.

My prints have a few visible horizontal lines in them near the bottom of the print. This has happened on a few different batches at similar points. What could be the cause?

Models were supported and sliced in chitubox. The photo shows the lines. The models were printed around 45° so the lines were parallel to the build plate. My photon has dual z axis guide rails.

翻譯年糕

Seem to be getting the hang of this.... Printed on photon with dual z axis guide rail at 0.05. Eco resin macaroon orange.

翻譯年糕

Hello folks,

I have been getting some nice prints using orange Eco resin, now I want to try some bigger things....

I know it is recommended to hollow out larger objects due to uncured resin being trapped inside, but how deeply can resin cure? At what thickness should I consider hollowing a mosel?

I tried google but I couldn't find anything. I assume there is no absolute answer, just looking for a general guideline.

Thanks for any ideas.

翻譯年糕

Hello everyone,
I finally got a chance to run my photon for the first time and of course I have lots of questions! (and pictures). I got my photon recently and then read about the "fauxton". I think I lucked out and got an original, the first picture shows the software pre-installed on my printer. Am I correct? My first print (second pic). Was failing so I stopped it. Made a little video. The resin seems to be pulling slightly on the fep causing the thin part of the model near the base to flex. Is that the problem here? The last 3 pics show print 2. This came out a lot better, but the model was still moving a little and it is not truly square/straight. I am using anycubic eco resin (macaron orange). My first print was done with default settings (just to see what happened). For print 2 I used some settings I found in a comment here (credit to poster). These really improved the print quality, but it is still not straight and moving slightly while printing. It also took 6 hours 11 minutes! How could I improve these settings? 翻譯年糕