Hi everyone,
I'm having problems with the printer not forming any models although it is completing a print without any errors.
I have noticed that on the touchscreen that the model
is highlighted as red if i go back to select the model for another print as opposed to green.
I have only got around to trying the Anycubic, so maybe the fact the the resin i am using is outdated (August 2018) is the problem. Although the resin bottle was unopended and shaken well before use. It looks fine in the vat.
Please look at my print settings and slicer setups - i have followed recommeneded settings from the community spreadsheet.
There is a 1/3 amount of resin in the vat as recommended
Maybe another clue is that with the Meeples model print, there are maybe a few layers that are formed within the resin at the base of the vat - you can see a faint outline in the photo of the vat.
Thanks for any help
翻譯年糕
Octavio Carlo
2019-12-13 20:44:01
Durril Weller
2019-12-13 20:45:14
Octavio Carlo
2019-12-13 20:45:44
Durril Weller
2019-12-13 20:47:00
Octavio Carlo
2019-12-13 20:47:36
Vít Kuře Prokop
2019-12-13 20:47:38
Octavio Carlo
2019-12-13 20:47:50
Octavio Carlo
2019-12-13 20:48:34
Octavio Carlo
2019-12-13 20:49:45
Luis Bivar Ramos
2019-12-13 20:51:16
Durril Weller
2019-12-13 20:53:27
Durril Weller
2019-12-13 20:55:12
Durril Weller
2019-12-13 20:56:13
Octavio Carlo
2019-12-13 20:57:28
Fred Bey
2019-12-13 20:58:49
Catherine Lim Sook Yee
2019-12-13 20:59:13
Luis Bivar Ramos
2019-12-13 20:59:16
Luis Bivar Ramos
2019-12-13 20:59:44
Catherine Lim Sook Yee
2019-12-13 20:59:48
Luis Bivar Ramos
2019-12-13 21:00:58
Catherine Lim Sook Yee
2019-12-13 21:01:00
Durril Weller
2019-12-13 21:06:41
Durril Weller
2019-12-13 21:21:07
Durril Weller
2019-12-13 21:30:44
Ahmed Hebishi
2019-12-13 22:30:33
Chad Elstad
2019-12-14 11:35:23
Khoa Truong
2019-12-14 15:27:12
Landon Alumbaugh
2019-12-14 23:18:30
Durril Weller
2019-12-14 23:21:02
Durril Weller
2019-12-14 23:25:03
Chad Elstad
2019-12-14 23:26:34
