Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I just received my new photon yesterday and printed the test file and it went great. This morning wanted to update the firmware (came with V3.4.1) but my photon will not read the update.LCD file on startup and only the .bin file shows up under print and it says file error when I try to read it. Has anyone had similar issues? Is there a different way to update to v4.x first from v3.4.1 that is different from putting all of the files on a blank (I tried reformatting the drive to make sure) usb drive and plugging it in then starting up the photon? Any advice would be very appreciated!

翻譯年糕

I just ordered my photon and had some questions about resin. Assuming cost is a non-factor, I plan on ordering 1000g of Siraya Tech Blu along with either Siraya Tech Fast Grey or Elegoo Grey. I plan to use the photon for mostly miniatures and hope to paint them, so I was wondering if anyone had recommendations about which of the latter two to try first for paintability, durability, and a little bit of flexibility (not brittle). Also if anyone has mixed either of the latter two with the Blu and knows which mixes best that info would be great as well! Thanks!

翻譯年糕