Hey guys. Having a lot of failed prints lately. Not sure what im doing wrong. I'm still getting used to the photon s apparently. I put 6 models in the slicer. all of them leaning back. so the supports would hit there. floating off build plate so that the supports do the heavy lifting. using Anycubic Grey resin.
Settings:
.02 layer height.
8 bottom layers
exposure time 14
bottom exposure 90
light offs 1s.
With this print. the 3 models on the back side of the build plate are still there. the front 3 are gone. not sure if this is a leveling issue or what. i thought the leveling was really only side to side and the back to front was basically handled when mounting the plate.
should i stop this print with 4 hours still to go and just scrap the ones on the back? if there was issue enough for 3 to not work - i assume the back ones are even going to come out correctly.
I having a lot harder time with getting consistent good results with the photon over any FDM printer ive had.
翻譯年糕
